[Mainia1]

I just added these last night, I spun off the OEM horn itself from it's bracket, so the braket was still there. I then TIG welded a bolt the fitted through all the mounting holes to one of the new horns mounting brackets. I added a star lock washer in between the two horns to keep them in place from each other when bolted down. I wired two wires into one of those slide on electrical fittings they use in cars and boats 12 volt applications. Coated all wires with die electric grease and inside connection fittings and all over the horns electrical fittings. I then added another fitting to one side of the wires to tap TO the other horn's electrical connection. Before this I cut the power harness plug end off and used these Wago plastic connectors and added some die electrical grease inside these. This made an easy connection because it WAS a pain in the ars install, because of being on your back and no room /weird position. Going through the fender well would be a better way. I committed going from under, so I just kept going with that choice. No need for a relay till I see a blown fuse.



https://www.amazon.com/gp/product/B01EG18K1Y/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1


https://www.menards.com/main/electr...re-lever-nut/51194809/p-1444446000167-c-6447.htm?tid=5215699174985197177&ipos=2


.

 

[Mainia1]

Nice job, you will wake someone up with those.

 

[Mainia1]

Pathetic Horn

This horn is a joke they put in the Kona , who here has replaced it or know's where is it located ? I ordered some Hella horns off of Amazon and I'm ready to go !

www.hyundaikonaforum.com