Hyundai Kona Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #3
The outlet of the duct is aimed right at the intercooler, should provide better cooling. But, the end goal was to make a template that I could mount any aftermarket LED fog in the original spot to rid the Halogen units.
 

·
Registered
Joined
·
46 Posts
Cool idea! Are you using PLA? I printed a trim piece once out of PLA for a Ford Focus RS and it was close to the grill. It ended up warping quite a bit due to the heat from the engine.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #5
Cool idea! Are you using PLA? I printed a trim piece once out of PLA for a Ford Focus RS and it was close to the grill. It ended up warping quite a bit due to the heat from the engine.
I'm using PLA for the prototypes, but the finished ones will be PETG.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #8
Update, installed this morning. Minor mounting tweaks needed but happy with it overall. Second picture shows a direct air shot to the intercooler.
5261
5262
 
1 - 8 of 8 Posts
Top