Sorry to bring an old post up. I have just bought a Kona.
Do these bulbs have any problem with the car telling you that the bulbs have blown as they are aftermarket? I have heard problems elsewhere with new bulbs installed.
Just a bump.
Wondering if you have any advice to offer on how to install without killing the bulb/ or hands.
The passenger side seems blocked by the washer fluid stem. Did you remove the headlight assembly?
Inquiring minds want to know. ;-)
You only have to move the reservoir stem if you are replacing the high beams as well. It is doable without removing the assembly but you just have to be patient. There is a little plastic access point in the wheel well that you could go through - the only down side to this is that you would have to drill out a couple rivets. Why they chose to rivet this on is beyond me as this should just be a couple of screws. You could drill those out and reassemble with a stainless screw and nut.
I just used my hand and rubber gloves so I didn't get hand oils on the bulb - no problem scratching the bulb or cutting my hands, a few scratches but that was it.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hyundai Kona Forum
41.3K posts
10.9K members
Since 2017
Hyundai Kona Forum - the best place to talk about the new Hyundai Kona, the new city SUV and its upcoming Kia twin!